MIFAB® Series BIG-_____ FUR (indicate model) HDPE rotationally molded fur interceptor with a liquid holding holding capacity of ______ (indicate).
Interceptor has a limited lifetime warranty and is made in the USA out of seamless, rotationally molded High Density Polyethylene with a 3/8” uniform wall thickness. Interceptor is designed for above or below ground installation and includes extension pipe gasket for ADS 18N12 (pipe not included) for the adjustable lid system, sample port access, dual strainer baffles with 3/8” diameter holes (1/2” apart), deep seal trap covered by the lid and 4” no hub inlet and outlet connections. Ductile iron pickable lids, H-20 rated, proof-load tested to 40,000 lbs. provide a water / gas tight seal. The lids are designed in accordance with the loading requirements of AASHTO H-20. The high density polyethylene material is PE 3135 from Dow 9.39 with a density of 0.939 g/cm3. For indoor / outdoor use.
Downloads
General
Terms and Warranty
Installation
General
BIG-500 Installation Guide
BIG-750 Installation Guide
BIG-1150 Installation Guide
Lid Installation Instructions
Extension Installation Instructions
Venting Installation Instructions
Anchor Kit
BIG-55 Anchor Kit Installation Guide
BIG-140 Anchor Kit Installation Guide
Pump Out and Vent Connections
BIG-140 Locations for Pump Out Connections
BIG-300 Locations for Pump Out Connections
BIG-140 Locations for Vent Connections
BIG-300 Locations for Vent Connections
Technical Documents
Specification Sheets
BIG-SP Specification Sheet
Test Reports
H-20 Load Rated Lid Test Results
Bury Depth IAPMO
Cross References
Cross Reference Green Turtle Schier
CSI Specifications
BIG-MAX