MIFAB® SUPER-1300 gravity grease interceptor with 1,300 U.S. gallons of liquid holding capacity has a limited lifetime warranty and is made in the U.S.A. out of seamless, rotationally molded High Density Polyethylene with 3/8” uniform wall thickness. Interceptor is designed for above or below ground installation and includes an adjustable lid system, sample port access, internal baffle, deep seal trap covered by lid, internal air relief by-pass, stainless steel calibrated orifice plate (internal flow control), base for support and floor level installation and 4″ no hub inlet and outlet connections. Composite lids provide a water / gas tight seal and have a minimum of 20,000 LB. load capacity – in accordance with the loading requirements of AASHTO H20. The high density polyethylene material is PE 3135 from Dow 9.39 with a density of 0.939 g/cm3. The -PDI model is tested and certified to the PDI G-101 Standard, 100 GPM flow rate. For indoor/outdoor use.
Hydromechanical Gravity Spec. Sheet 
Catalog
List Pricing
Current Catalog: INT-2024
Installation
General
SUPER-MAX Installation Guide
Lid Installation Instructions
Venting Installation Instructions
Remote Pump Out Kit
Grease Interceptor Maintenance Guide
Anchor Kit
SUPER-MAX Anchor Kit Installation Instructions
Other
SUPER-MAX Locations for Pump Out Connections
SUPER-MAX Locations for Vent Connections
Technical Documents
Test Reports
H-20 Load Rated Lid Test Results
IAPMO Approval
Bury Depth IAPMO
Cross References
Cross Reference Green Turtle Schier
Other
SUPER-MAX
SUPER-MAX Sell Sheet
Sampling Port
ASME Approval
ANSE Z1001 Approval
Lifetime Warranty