MIFAB® Series BIG-140-S HDPE rotational molded sand interceptor with 75 GPM flow rating and sand holding capacity of 63 lbs. Interceptor has a limited lifetime warranty and is made in the U.S.A. out of seamless rotationally molded high density polyethylene with 3/8” uniform wall thickness. Interceptor is designed for above or below ground installation and includes extension pipe gasket for ADS 18N12 (pipe not included) for the adjustable lid system, sample port access, deep seal trap covered by lid, internal flow control set to 100 GPM and 4” no hub inlet and outlet connections. Ductile iron pickable lids, H-20 rated, proof-load tested to 40,000 lbs., provide a water / gas tight seal. The lids are designed in accordance to the requirements of AASHTO H-20. The high density polyethylene material is PE 3135 from Dow 9.39 with a density of 0.939 g/cm3.
Downloads
General
Terms and Warranty
Installation
General
BIG-500 Installation Guide
BIG-750 Installation Guide
BIG-1150 Installation Guide
Lid Installation Instructions
Extension Installation Instructions
Venting Installation Instructions
Anchor Kit
Pump Out and Vent Connections
Technical Documents
Specification Sheets
Test Reports
Cross References
CSI Specifications